normal load
英 [ˈnɔːml ləʊd]
美 [ˈnɔːrml loʊd]
正常（额定，标称，垂直）负载
双语例句
- Now that you are logging information from the garbage collector, run your application under normal load.
启用垃圾收集器的日志记录之后，在正常负载下运行应用程序。 - All Web sites should be ready to handle traffic several orders of magnitude greater than normal load.
所有Web站点都应该准备好处理比普通负载高几个数量级的通信量。 - The results show that the static coefficient of friction ( SCOF) between rubber and floor tile decreases with the increase of normal load, but the rate of decrease is reduced.
结果表明：摩擦因数随着载荷的增加而增加，随着滑动速度的增加而减小；磨损率随着载荷的增加而增加，随着滑动速度的增加先增加而后降低。 - In order to achieve accurate measurement under normal load and lower load, this paper produces a project of three-phase watt-hour meter, with real-time subsection according to load power.
以实现超低负荷和正常负荷两种情况下的精确计量为目标，提出实时分段计量的电度表设计方案。 - The results show that the resonance frequency of the blade increases with the increase of normal load.
计算结果表明：系统的共振频率随正压力的增大而增大； - Not a normal load paperwork, but an unusually large amount, which kept you from doing what you do best: Working with people.
书面工作的量不是一般的多，而是多的不同寻常，这样会让你没办法去做你做的最棒的事情：和人打交道。 - A load-break switch will switch normal load currents but will not interrupt short circuit cur-rents.
负荷开关可开断正常负荷电流但不能开断短路电流。 - Operation under normal load for a specified period, starting from cold, the intervals after each period of operation being sufficient to allow the equipment to cool down to room temperature.
常规负载下特定时间段的一种操作，该时间段从冷态开始，到使设备到达室温的间隔。 - The experimental results show that the adhesion increases with the magnitude of normal load at the logarithmic rule;
结果表明，负法向力（即粘着力）随法向力的增加而呈对数规律增加； - The figure that the solid line at different engine speeds to provide the maximum torque, while the dotted line that the normal load changes in the work of the compressor torque needed.
图中实线表示发动机在不同转速下能提供的最大转矩，而虚线表示负荷变动时压缩机正常工作需要的转矩。 - As the results, the friction coefficients decrease with increase of the sliding distance and normal load.
结果表明：碳化硼-碳化硼摩擦副的摩擦系数随滑行距离和载荷的增加而减小，最低摩擦系数为0.09； - Furthermore, in fretting test, the influence of vibration frequency, displacement amplitude and normal load on friction coefficient of the carbon nitride thin films was studied.
另外，还研究了在微动摩擦实验中振动频率、振幅和载荷对摩擦系数的影响。 - The influences of film thickness, normal load, and sliding speed on the friction and wear behaviors of PNMP films are investigated.
研究考察了薄膜厚度、法向负荷以及相对滑动速度对PNMP薄膜的摩擦和磨损性能的影响。 - Dispatchers should arrange reasonable operation modes based on the normal load flow condition.
调度员在正常运行情况下要根据负荷潮流合理安排运行方式； - And that tangential force increases with magnitude of negative normal load at the linear rule.
在负法向力（即粘着力）下，切向力随负法向力的增加按线性规律增加。 - With rising normal load, the wear volume loss ascends but the friction coefficient decreases.
载荷增加时，磨损体积增大而摩擦因数减小； - At low normal load and sliding speed, the main wear mechanism of 3Y-TZP is plastic deformation.
在低载低速下3Y-TZP陶瓷的主要磨损机制为塑性变形； - Loading experiment proved that under normal load effect the structure was basically in plastic working state.
模型的荷载试验表明，在正常使用荷载作用下结构基本处于弹性工作状态。 - The calculation results indicate that the microslip of a damper can markedly reduce the responses of vibration system, and that there is an optimal normal load, under which the response of the vibration system is minimum at the resonance in the system.
通过对带摩擦阻尼器平板叶片的振动响应分析，结果表明：阻尼器在局部滑动阶段，对系统振动的抑制有明显的效果，并且适当施加正压力能使系统在共振状态下的响应达到最小。 - Linear regression analysis of past load and weather data is used to identify the normal load model. The weather-sensitive component of the load is estimated using the parameters of the regression analysis.
对过去的负荷和天气数据进行线性回归分析，可辨别出正常负荷模型，而负荷的天气敏感部分是运用回归分析的参数来估计的。 - The results shown that the vibration type of frictional force is quasi-harmonic self-excited vibration in vacuum, it is not related to normal load and pulling velocity, and its vibration frequency in horizontal direction is approximate to the natural frequency of the sample system.
结果表明，真空中摩擦力振动的类型呈准谐波周期性自持振动，其与正压力及拖动速度无关，振动频率接近于系统在水平方向上的固有频率； - The external load born by the U-shape frame is analyzed under normal load condition. A finite element analysis model is established. The distributions of the structural stresses and deformations are obtained.
分析了推土机U型架在正载工况下所受外载荷，建立了有限元分析模型，求得了结构应力及变形分布。 - Coefficients of friction decreased as normal load increased for the same friction pair.
随法向载荷的增加，同一摩擦副的摩擦系数降低。 - Variations of normal load vs displacement between two contact surfaces have been analyzed as a function of cycles.
分析了随循环周次的变化，两接触表面间法向载荷与位移的变化规律。 - The results are drawn as follows: 1. Displacement and normal load have influence on wear volume and friction coefficient.
结果表明：1.位移幅值与法向载荷对微动磨损的摩擦系数和磨损量都有影响。 - To satisfy flight constraints, the trajectory programming based on angle-of-attack and normal load command is present.
考虑飞行约束，给出了基于迎角指令和过载指令的轨迹设计方法。 - The average friction coefficients present a similar variation with normal load and sliding velocity for the two nitrided layers during the dry sliding in vacuum.
在真空干滑动时两种渗氮层的平均摩擦系数随法向载荷和滑动速度的变化趋势相似。 - The fretting wear behavior of the coatings and substrate were investigated systematically under different displacement, normal load and temperature. And the mechanism of high temperature fretting wear was studied.
系统研究了涂层和基体在不同位移幅值、法向载荷及温度的磨损行为，探讨了其高温微动磨损机理。 - With the increasing of the displacement and normal load, both the wear volume and the friction coefficient increase. 2. Temperature has great influence on the fretting wear.
随着位移幅值和法向载荷的增加，摩擦系数和磨损量分别增大。2.温度对微动磨损有重要的影响。 - When the normal load and the sliding speed increased, the friction coefficient decreases.
随着法向载荷和滑行速度的增大，摩擦因数减小。